Filter
Top Products
3
Model 390 Safety
040419
Section 3 Safety
We at Taylor Company are concerned about the safety
of the operator when he or she comes in contact with
the freezer and its parts. Taylor has gone to extreme
efforts to design and manufacture built-in safety
features to protect both you and the service technician.
As an example, warning labels have been attached to
the freezer to further point out safety precautions t o the
operator.
IMPORTANT -- Failure to adhere to the
following safety precautions may result in severe
personal injury. Failure to comply with these
warnings may damage t he machine and its
components. Component damage will result in
part replacement expense and service repair
expense.
To Operate Safely:
DO NOT operate the freezer without reading
this operator’s manual. Failure to follow this instruction
may r esult in equipment damage, poor freezer
performance, health hazards, or personal injury.
S DO NOT operate the freezer unless it i s
properly grounded.
S DO NOT operate the freezer with larger
fuses than specified on the freezer data
label.
S DO NOT attempt any repairs unless the
main power supply to the freezer has been
disconnected.
Failure to follow these instructions may result in
electrocution o r dam age to the machine. Contact your
local authorized Taylor Distributor for service.
DO NOT use a water jet to clean or rinse the
freezer. Failure to follow this instruction may result in
serious electrical shock.
S DO NOT allow untrained personnel to
operate this machine.
S DO NOT operate the freezer unless all
service panels and access doors are
restrained with screws.
S DO NOT remove the door, beater, scraper
blades or drive shaft unless the control
switch is in the “OFF” position.
Failure to follow these instructions may result in severe
personal injury to fingers or hands from hazardous
moving parts.
S USE EXTREME CAUTION when removing
the beater assembly. The scraper blades
are very sharp and may cause injury.
S DO NOT put objects or fingers in the door
spout.
Failure to follow these instructions may result in
contaminated product or personal injury from blade
contact.
This freezer must be plac ed on a level surface.
Failure to comply may result in personal injury or
equipment damage.
DO NOT obstruct air intake and discharge openings:
6” (152 mm) minimum air space on both sides, and 0”
at the rear of the freezer. Failure to follow this
instruction may cause poor freezer performance and
damage to the machine.
NOISE LEVEL: Airborne noise emission does not
exceed 78 dB(A) when measured at a distance of 1.0
meter from the surface of the machine and at a height
of 1.6 meters from the floor.