Filter
Top Products
19
Model 632 Operating Procedures
Freezing Cylinder Assembly --
Shake Side
Note: When lubricating parts, use an approved food
grade lubricant (example: Taylor Lube).
MAKE SURE CONTROL SWITCH IS IN THE
“OFF ” POSITION. Failure to do so may cause injury
from hazardous moving parts, or electrocution.
Step 1
Install the drive shaft. Lubricate the groove and shaft
portion that comes in contact with the bearing on the
beater drive shaft. Slide the seal over the shaft and
groove until it snaps into place. DO NOT lubricate the
hex end of the drive shaft. Fill the inside portion of the
seal with 1/4” more lubricant and lubricate the flat side
of the seal that fits onto the rear shell bearing.
Figure 1 9
Insert the drive shaft into the freezing cylinder, hex end
first, and into the rear shell bearing until the seal fits
securely over the rear shell bearing. Engage the hex
end firmly into the drive coupling. B e sure the drive
shaft fits into the drive coupling without binding.
Figure 2 0
Step 2
Install the beater assembly. First check the scraper
blades for any nicks or signs of wear. If any nicks are
present, replace the blade(s).
Figure 2 1
Note: To prevent costly damage, the hole on the
scraper blade must fit securely over the pin.