Filter
Top Products
22
Operating Procedures
Model 632
Step 4
Place the power switch in the ON position.
Figure 3 1
Step 5
Press the WASH key. This will cause the sanitizing
solution in the freezing cylinder to agitate. Allow it to
agitate for five minutes.
Figure 3 2
Step 6
Place an empty pail beneath the door spout. Raise the
primeplug(softservesideonly).
Figure 3 3
Step 7
When a steady stream of sanitizing solution is flowing
from the prime plug opening in the bottom of the
freezer door, open the draw handle. Draw off a ll the
sanitizing solution.
Figure 3 4
Step 8
Once the sanitizer stops flowing from the door spout,
close the draw handle and press the W ASH key,
cancelling the beater motor operation.
Note: You have just sanitized the freezer. Be sure
your hands are sanitized before continuing these
instructions.
Step 9
Stand the air tube in the corner of the hopper.
Figure 3 5
Repeat steps 1 through 9 for the shake side of the
freezer.