Filter
Top Products
16
Models 8751/8754Operating Procedures
Slide the two o-rings into the grooves on the prime
plug(s). Apply an even coat of Taylor Lube to the
o-rings and s haft(s).
Figure 9
Note: There a re t wo prime plugs for the M odel 8754
door, one for each f reezing c ylinder.
Insert the prime plug(s) into the hole(s) in the top of the
freezer door, and push down.
Figure 10
Step 4
Install the freezer door. Insert the baffle rod(s)
through the opening in the beater(s) and seat t he door
flush with the freezing cylinder. With the door seated
on the freezer studs, install the handscrews. T ighten
equally in a crisscross pattern to insure the door is
snug.
Note: On the Model 8754, the short handscrews go
on the bottom and the long handscrews go o n the top.
Figure 11
Step 5
Install the draw valve(s). Slide the two o-rings into
the grooves on the draw valve(s), and lubricate.
Figure 12
Note: The M odel 8754 has three draw valves.
Lubricate the inside of the freezer door spout(s), top
and bottom, and insert the draw valve(s) from the
bottom until the slot in the draw valve(s) comes into
view.
Figure 13