Filter
Top Products
21
Models 8751/8754 Operating Procedures
Install the hex end of the drive shaft into the drive hub
at the rear wall of the mix hopper.
Figure 31
Note: For easein installingthe pump, position theball
crank of the drive shaft in t he 3 o’clock position.
Step 9
Lay the pump assembly, pump clip, mix feed tube,
locking clip, and gasket in the bottom of the mix hopper
for sanitizing.
Figure 32
Repeat Steps 1 through 9 for the other side of the
freezer on the M odel 8754.
Sanitizing
Step 1
Prepare two gallons (7.6 liters) of an approved 100
PPM sanitizing solution (example: Kay-5r). USE
W ARM WATER AND FOLLOW THE MANUFACTUR-
ER’S SPECI FICATIONS.
Step 2
Pour the two gallons (7.6 liters) of sanitizing solution
over all the parts in the bottom of the mix hopper and
allow i t to flow into the freezing cylinder.
Figure 33
Note: You have just sanitized the mix hopper and
parts; therefore, be sure your hands are clean and
sanitized before going on in these instructions.
Step 3
While the solution is flowing into the freezing cylinder,
take particular care to brush-clean the mix level
sensing probe on the front wall and the bottom of the
hopper, the mixhopper,the mixhopper gasket, themix
inlet hole, theair/mix pump, the pump clip, the mix feed
tube, and the locking clip.