16
Model C707Operating Procedures
080815
Step 4
Install the draw valve. Slide the two o--rings into the
grooves on the draw valve, and lubricate.
Figure 8
Lubricate the inside of the freezer door spout, top and
bottom, and insert the draw valve from the top until the
draw valve is at the bottom.
Figure 9
Slide the two o--rings into the grooves on the prime
plug. Apply an even coat of Taylor Lube to the o--rings
and shaft.
Figure 10
Insert the prime plug into the hole in the top of the
freezer door, and push down.
Figure 11
Step 5
Install the adjustable draw handle. Slide the fork over
the bar in the slot of the draw valve. Secure with pivot
pin.
Figure 12
Note: This unit features an adjustable d raw handle to
provide the best portion control. The draw handle can
be adjusted for different flow rates. See page 12 for
more information on adjusting this handle.
Step 6
Install the freezer door. Insert the baffle rod through
the opening in the beater and seat the door flush with
the freezing c ylinder. With the door seated on the
freezer studs, install the handscrews. Tighten equally
in a crisscross pattern to insure the door is snug.
