Filter
Top Products
18
Model C707Operating Procedures
080715
Sanitizing
Step 1
Prepare an approved 100 PPM sanitizing solution
(examples: 2--1/2 gal. [9.5 liters] of Kay--5 R or 2
gal. [7.6 liters] of Stera--SheenR). USE WARM WA-
TER AND FOLLOW THE MANUFACTURER’S
SPECIFICATIONS.
Step 2
Pour the sanitizing solution over all the parts in the
bottom of the mix hopper and allow it to flow into the
freezing cylinder.
Figure 18
Note: You have just sanitized the mix hopper and
parts; therefore, be sure your hands are clean and
sanitized before going on in these instructions.
Step 3
While the solution is flowing into the freezing cylinder,
take particular care to brush--clean the mix level
sensing probe on the front wall and the bottom of the
hopper, the mix hopper, and the feed tube.
Figure 19
Figure 20
Figure 21
Step 4
Place the power switch in the ON position.
Figure 22