Taylor C708 Refrigerator User Manual


 
32
Models C708 & C716Operating Procedures
Section 6 Operating Procedures
The C708 stores mix in a hopper and has a 3.4
quart (3.2 liter) capacity freezing cylinder with a
single spout door. The C716 s tores mix in two
hoppers and has t wo 3.4 quart (3.2 liter) capacity
freezing cylinders with a three s pout door.
The Model C708 has been selected to illustrate the
step-by-step operating procedures. Duplicate the
procedures, where they apply, for the second
freezing cylinder on the Model C716.
We begin our instructions at the point where we
enter the store in the morning and find the parts
disassembled and laid out to air dry from the
previous night's cleaning.
These opening procedures will show y ou how to
assemble these parts into the freezer, sanitize them,
and prime the freezer with fresh mix in preparation
to serve your first portion.
If you are disassembling the machine for the first
time or need information to get to t his s tarting point
in our ins tructions, turn to page 47, “Disassembly”,
and start there.
Freezing Cylinder Assembly
Note: When lubricating parts, use an appr oved food
grade lubricant (example: Taylor Lube).
MAKE SURE THE POWER SWITCH IS IN
THE “OFF” POSITION! Failure to follow this
instruction may result in severe personal injury from
hazardous moving parts.
Step 1
Before installing the beater drive shaft, lubricate the
groove on the beater drive s haft.
Step 2
Slide the beater drive shaft boot seal over the s mall
end of the beater dr ive shaft and engage into the
groove on the s haft.
Step 3
Heavily lubricate the inside portion of the boot seal
and also lubr icate the flat end of the boot seal that
comes in contact with the rear shell bearing.
Step 4
Apply an e ven c oat of lubr icant to the shaft. DO
NOT lubricate the hex end. ( See Figure 12.)
Figure 1 2
Note: To ensure the mix does not leak out of the
back of the freezing cylinder, the middle s ection of
the boot seal should be c onvex or ex tend out from
the seal. If the middle section of the boot seal is
concave o r extending into the middle o f the s eal,
turn the s eal ins ide out.
Step 5
Insert the beater drive shaft through the rear s hell
bearing in the f reezing cylinder and engage the hex
end firmly into the drive coupling. (See Figure 13.)
Figure 1 3