Filter
Top Products
16
Models RD30/RC25Operating Procedures
Place the door spout seal o--ring into the groove in the
door and lubricate the components.
Figure 16
Align the draw spout assembly with thedoor. Place the
draw spout mounting plate over the draw spout
assembly and align the holes.
Figure 17
Using the thumb screws, fasten the draw spout
assembly and draw spout mounting plate to the door.
Figure 18
Place the large o--ring into the groove on the back side
of the door and lubricate the installed o--ring.
Figure 19
Place the door bearing onto the hub on the back side
of the door with the flanged end of the bearing facing
the door.
Note: Do not lubricate the door bearing.
Step 5
Install thefreezer door. P osition thedoor onthefreezer
studs at the front of the freezing cylinder . Press the
door firmly into place.
Note: The torque rotor will protrude through the hole
in the center of the door.
Figure 20