Filter
Top Products
15
Models RD30/RC25 Operating Procedures
Insert the torque rotor (guide bearing end first) into the
pilot holein the c enter of the drive shaft. The holein the
torque rotor shaft should be rotated to the 12 o’clock
position.
Figure 12
Step 4
Install the freezer door. Slide the draw valve o--ring
into the groove on the draw valve and lubricate the
o--ring.
Figure 13
Place the draw valve spring over the shaft end on the
draw valve.
Figure 14
Insert the draw valve and spring into the door spout
until the threaded end of the shaft passes through the
hole in the end of the door spout. Thread the draw
valve knob onto the end of the draw valve shaft.
Figure 15