Thermador KBUIT4255E Refrigerator User Manual


 
269
1.800.735.4328 | THERMADOR.COM
REFRIGERATION — SIDE-BY-SIDE
SIDE-BY-SIDE STAINLESS STEEL SERIES SIDE PANELS
Custom side panels may be needed when not enough space is
available to have cabinets on both sides of the refrigerator or
when the refrigerator is placed at the end of a cabinet run. You
may choose an Inset, Flush, or Recessed Inset panel installation.
REFRIGERATOR AND SIDE TRIM DIMENSIONS
The width and height of a side panel are determined by the type
of installation you are planning.
Notes:
– The dimensions shown are actual product dimensions and may
not reflect the needed panel installation dimensions.
– The side panel should be a minimum of
1
/2" (1.27 cm) thick to
avoid warping.
– If the opening depth is 25" (63.5 cm) or more, you may want to
install a support board on rear wall.
INSET INSTALLATION DIMENSIONS
1. Measure the distance from point A (as shown) to the back
wall. Add
7
/32" (5.6 mm) to this measurement to allow the side
panel to fit into the trim.
2. If the panel is more than
1
/4" (6.35 mm) thick, route the front
edge to allow the side panel to fit into the trim.
RECESSED INSET INSTALLATION DIMENSIONS
1. Measure the distance from point A (as shown) to the back wall.
2. Route the front edge of the support board or attach a
1
/4"
(6.35 mm) board to hold the panel in the cabinet side trim.
Refrigerator
24
"
(61.3 cm)
23
 "
(59.7 cm)
23 "
(60.3 cm)
 "
(4.5 mm)

"
(6.35 mm)
 "
(4.7 mm)
 "
(5.5 mm)
 " (10 mm)
"
(15.7 mm)
Side Trim
A
A
A
FLUSH INSTALLATION DIMENSIONS
1. Measure the distance from point A (as shown) to the back wall.
2. Attach the support board with a screw or adhesive that is
compatible with aluminum and wood.