Filter
Top Products
COOK'N'VENT _ VENTILATOR CARE*
Section Five: Care & Maintenance
See "SAFETY PRACTICES,"
on Page 4.
The efficiency of the exhaust system
depends on the cleanliness of the
ventilator, especially the filters. The
frequency of cleaning depends on
the amount and type of cooking pre-
formed.
FILTERS and INTAKE
PANEL
Filters become soiled in a short pe-
riod of time and should be cleaned
regularly. The filters may be cleaned
by agitating them in a hot detergent
solution or by washing in the dish-
washer.
Do not use the ventilating system ]
without the filters in place.
TO REMOVE THE FILTERS
AND CLEAN THE PANEL
ix _'---r-
il 7-114 II
.
Raise the Vent to its
Maximum Height
Raise the ventilator intake to its
maximum height. If the blower
is on, turn it off.
Ventilator
Ca.
//, i17 Panel
.
Grasp the front panel at the top
towards the sides and pull up
and forward: remove and set
aside.
.
Remove the ventilator cap by
grasping both ends of the cap
and lifting up.
4. Lift out the filters and clean.
Scrape
Grease Off
.
Using a nylon or other soft-touch
spatula, lift the accumulated
grease from the back panel - be-
hind the filters. Clean front and
back panels using a mild grease
solvent (See Cleaning Chart for
Stainless Steel).
TIP: Wipe the intake off |
after each use.
J
TO REPLACE THE FILTERS
AND THE FRONT PANEL
.
.
.
Place Filters side by side
Place the filters side by side on
the support bars in front of the
back panel. They will lean for-
ward and the tops will rest
against the inside of the front
panel supports.
Replace ventilator cap. Be cer-
tain all sides of the cap fit inside
the ventilator sides and back
panel.
Replace the front panel by hook-
ing the lower front edge of the
front panel over the lower front
edge of the ventilator.
.
Side Supports
Hook over Side
Supports
Hook the top of the front intake
panel over the side supports at
the top of the ventilator.
Cover and Vent Going Down
10. As the ventilator intake is low-
ered, the cover will return to its
position covering the ventilator.
To Clean Gap Area
Between Ventilator &
Cooktop
1. With ventilator in up position,
remove front panel, ventilator
cap and filters.
2. Lower ventilator completely.
3. Clean gap area using a mild
grease solvent (see Cleaning
Chart).
4. Raise ventilator completely and
replace filters, cap and front
panel.
* Not on all Models.
Page 26