Filter
Top Products
Page 4
A. Motor OFF button
B. ON button and motor speed
selection button 1, 2, 3, 1,....
C. Speed 1LED
D. Speed 2 LED
E. Speed 3 LED
F. Timer LED
G. Timer.
If the motor is off while the
timer is pressed the motor will
run at speed 3 for 20 minutes
then stop.
If the motor is running when the
timer key is pressed the motor
will continue to run for 10
minutes. After 10 minutes the
motor will stop.
Pressing the timer or speed
button while the Timer LED is
on will disable the timed mode.
H. Light ON/OFF button.
I. Dim Light ON/OFF button (only
for model HTNI).
Grease Filter Saturation LED
The speed 2 LED in Figure 1 in
is marked with an F. This LED will
flash to remind you when the grease
filter needs to be cleaned after 40
hours use. Follow the instructions
for cleaning filters in thisFollow the
instructions for cleaning filters in
this booklet. Once the grease
filters have been cleaned, reset the
display by pressing button A for 3
seconds until you hear the signal
(beep).
Circuit Self-test
The control allows the user to
perform a self-test to check the
correct function of the hood.
The self test is activated by pressing
the A and B keys simultaneously
for 3 seconds.
The self-test procedure order is:
1. Four LEDs switch on.
2. Four LEDs switch off.
3. Blower runs at speed 1.
4. Blower runs at speed 2.
5. Blower runs at speed 3.
6. Blower off.
7. Lights switch on.
8. Lights dim (only for model
HTNI).
9. Lights turn off.
10. Beep signals end of self-test.
OPERATING
INSTRUCTIONS - HOOD
The blower should be turned on for
10 minutes before cooking in order
to establish air currents through the
hood. This will improve the capture
and removal of heat, smoke,
moisture, grease and cooking odors.
Use the low speeds for normal use
and the higher speeds for strong
odors or fumes.
Drafts across the range or cooktop
will reduce the effectiveness of the
hood. Such drafts should be pre-
vented when possible.
CONTROL PANEL
MODELS: HNI, HTNI
ELECTRONIC TOUCH CONTROLS
Fig. 1