Filter
Top Products
Page 7
Caution: The microwave oven is heavy. Al-
ways use at least two people to lift the unit.
1. Lift oven into position and rest right rear cor-
ner in cabinet cutout.
2. Reach past microwave on left side to insert
electrical cord into outlet.
3. Slide oven the rest of the way into the cabi-
net. Position microwave in cabinet so that
base pan center hole aligns with cabinet
centerline. When properly installed, the front
end of pan will be flush with the front edge
of the shelf.
4. Open the microwave door to access three
holes on the base pan below the microwave.
Drill 1/16" holes through the three (3) base
pan holes into the cabinet cutout bottom.
Fasten base pan to shelf with three 3 #8 x
3/8 Type A screws.
11. Install both vertical trim brackets on the cabi-
net using three (3) #8 x 3/8 Type A screws
on each side. The flanges on the ends of
the brackets should be inside the cabinet.
12. Snap frame trim into the trim brackets
(Figure 6). The four (4) ball studs on the
back of the frame snap into the four (4) spring
clips on the trim brackets. Tip: Place
screwdriver behind spring clip to support
bracket.
13. Install the plastic turntable. Place in center
of oven bottom with base in hole. Turn
turntable clockwise until it drops into place.
Place glass tray on top of turntable.
14. Test the operation of the microwave. See
the Care & Use manual for operating instruc-
tions.
Step 6: Completing the Installation
Figure 5
Figure 6
Frame Trim