Filter
Top Products
How to Use the Manual Seal Button
THE FOODSAVER USER MANUAL
15
THE FOODSAVER USER MANUAL
14
FoodSaver Designer Canisters are an excellent way to store
delicate items in the refrigerator, pantry or on the countertop.
1 Place the item(s) to be vacuum pack-
aged inside the canister. Leave at
least one inch between the contents
and the rim of the canister.
2 Insert one end of the Accessory
Hose into the Accessory Port on the
appliance. Insert the other end of the
Accessory Hose into the hole on the
top of the canister lid. Twist the gray
hose fitting while inserting to ensure
a tight fit.
3 Place the lid on top of the canister.
4 Set the Sealing Adjustment Switch to
“1” or “2.”
5 Vacuum package as per instructions
on page 10, steps 6-8.
6 Remove the Accessory Hose from
the lid by gently twisting the gray hose fitting and pulling up.
7 Vacuum packaging is complete.
How to Open FoodSaver Designer Canisters
To open a FoodSaver Designer Canister, press and hold down the
gray rubber button in the center of the lid. This will release the
vacuum and allow the lid to be removed.
IMPORTANT: Remember to remove the Accessory Hose from the
Accessory Port on the appliance before you vacuum package in
FoodSaver Bags. Remove the hose by gently twisting the gray
fitting while pulling it out. Never yank or tug the hose as this
may damage both the hose and the fitting.
Use the Manual Seal Button when you want to seal a FoodSaver
Bag before a complete vacuum has been created. This feature is
useful when vacuum packaging fragile items such as bread, baked
goods and berries so they don’t get crushed.
1 Open the lid.
2 Place the items to be vacuum packaged into the bag.
3 Place the open end of the bag down into the Vacuum Channel.
4 Close the lid.
5 Press and release the On button.
The appliance will automatically
begin the vacuum process.
6 To stop the process before all of
the air is removed, press and
release the Manual Seal Button. The vacuum will stop within 3
seconds and the sealing process will begin.
7 When finished vacuuming and sealing, the red sealing light will
blink, indicating the appliance is reprogramming itself. The lid
will open slightly.
Do not lift the lid until the red sealing light
stops blinking and the lid has reset to the ready position.
8 Open the lid and remove the bag.
NOTE: It takes approximately 2 to 3 seconds to stop the vacuum
process and seal the bag. If you are using a small bag or pack-
aging a fragile item, we recommend that you press down on the
Manual Seal Button immediately after releasing the On button.
How to Vacuum Package Using FoodSaver
Designer Canisters