Filter
Top Products
GRIDDLES
PAGE 5
Toastmaster
®
1. Free standing or counter top models
a. CAUTION: Be sure to follow all state
and local electrical codes when installing
the Toastmaster griddle.
b. Pull out the grease drawer and locate the
bag containing the 4” NSF approved,
adjustable legs. Models 7224, 7236 and
7324 are all furnished with 6 steel legs.
Model A710/A710S has 1 1/4” legs already
attached at factory.
c. Turn griddle on its back.
d. Thread each of the legs into the weldnuts
or leg mounting plates provided on the
bottom of the griddle. Tighten securely.
e. Place the griddle in position on the
counter where you have chosen for
installation. Using a common carpenters
level, you should level the griddle from side
to side and front to back by adjusting the
feet portion of the adjustable legs.
f. All Toastmaster counter top griddles
are provided with a terminal block in a
compartment at rear for electrical conne-
ction. Knockouts are also provided in
case bottom. See dimensional drawings
on pages 15-20 for knockout positions.
No internal wiring is necessary.
g. No internal fusing is provided on
Toastmaster counter top griddles. There-
fore, the installing contractor must provide
the proper disconnect as may be required
by state and local codes.
h. The Model A710 and A710S sandwich
grill comes standard with 36” cord and
plug.
i. Be sure the main power disconnect switch
is in the “OFF” position before attem-
pting to make any electrical connections.
B. Installation and Electrical Connections
Install legs with griddle on its back.
Adjust the leveling legs.