Filter
Top Products
USING THE DIGITAL FABRIC STEAM PRESS
7
Top Innovations, Inc.
FILLING WATER RESERVOIR
1. Place Digital Fabric Steam Press on a flat, level surface.
2. Turn Locking Knob to “Unlock” position to unlock Pressing Plate.
3. Lift up Pressing Plate using Handle. It will automatically stay in lifted position.
4. Pull Water Reservoir out. Note that Water Reservoir cannot be completely
removed from unit; do not attempt to force it free.
5. Remove Water Reservoir Cap to expose Water Reservoir fill hole.
6. Using Measuring Cup (included), fill Water Reservoir up to the MAX (300 ml)
line with distilled water.
7. Replace Water Reservoir Cap and push filled Water Reservoir back into main
unit.
OPERATING DIGITAL FABRIC STEAM PRESS
1. Plug power cord into electrical outlet, and set
On/Off Switch to “On” position (FIGURE 1).
2. Identify type of fabric you are going to press,
and select corresponding temperature setting
using Temperature Control Buttons. Note that it
is best to start with the most delicate fabrics
first, as higher levels of heat will cause damage
to Nylon and Silk.
3. Lay fabric flat on Ironing Board.
4. Digital Fabric Steam Press is ready for use when
Pressing Indicator Light deactivates. If pressing
wool, you may choose to spray with a burst of
steam. This function is available once Steam
Burst Ready Indicator Light illuminates.
FIGURE 1
NOTE: Do not activate burst of steam with unit completely closed, as this may
damage unit. Best results are obtained if Pressing Plate is held open approxi-
mately 75 mm above Ironing Board before pressing Steam Burst Button. For
safety reasons, do not hold Pressing Plate open more than 75 mm when using
steam burst function.
5. To press, lower Pressing Plate gently onto fabric and Ironing Board. Hold there
for 8-10 seconds, then lift up Pressing Plate. Repeat until you have achieved
desired crease and smoothness.
6. Once pressing tasks are complete, immediately set On/Off Switch to “Off”
position. Refer to page 9 of this manual for further information about cleaning
and storage of Digital Fabric Steam Press.