Filter
Top Products
USING THE DIGITAL FABRIC STEAM PRESS
8
Top Innovations, Inc.
STEAM BURST
1. Hold Pressing Plate approximately 3” above Ironing Board.
2. Press Steam Burst Button to release a burst of steam onto fabric.
3. Lower Pressing Plate onto fabric, then raise once again.
4. Repeat steps 1-3 above until fabric is smooth and wrinkle-free.
PRESSING AND STEAMING TIPS
Pressing Shirts and Blouses
1. Place shoulder yoke on Ironing Board first and press.
2. Next, place sleeves onto Ironing Board with fold parallel to long seam and press.
3. Place cuffs onto end of Ironing Board and press.
4. Place bottom of shirt behind Ironing Board. Begin by pressing the side with
pocket. Pull shirt towards you as you press each section.
5. Finish by pressing collar of shirt.
Pressing Pants
1. Place Pressing Cushion under waistband and press, repositioning waistband until
completely pressed.
2. To press inseam, place Pressing Cushion under area to be pressed.
3. Place pleated area on Ironing Board. Carefully fold pleats and press.
4. Embroidery should be placed face down on Ironing Board to reduce wear and
prevent damage to delicate areas.
Other Techniques
- Placing Pressing Cushion between fabric and Pressing Plate may help with
delicate fabrics.
- Buttons and zippers. If you have older types of buttons or zippers, you may need
to take special care to avoid melting. In order to do so, place garment face-down
and cover with Pressing Cushion before pressing.
- Spray Bottle may be used to spray fabrics lightly. This will further help to remove
exceptionally stubborn wrinkles.
- Place a damp cloth over fabric before pressing, which will help with stubborn
wrinkles or heavy gauge fabrics.
- To press large pieces of fabric, place entire piece behind Ironing Board. Pull
fabric towards you, over Ironing Board, and lower Pressing Plate. Press fabric in
sections until completed.