Filter
Top Products
Reassembling
The
Water Tank Valve Cap
If the plunger becomes separated from the Valve Cap,
follow the following procedure.
A. Grab the Value Cap Assembly and rotate it counter
clockwise about 1/8th of a turn. Lift straight up t
o
remove the cap.
The disk will most likely be found inside the water
container. Carefully drain the water from the container
B.
and search for the disk.
C.
Insure the spring is around the plunger.
D.
Place the small end of the plunger through the center
hole
of
the cap.
E.
Push the plunger through the central hole in the disk
until it pops into place.
Note: Be sure the disc is oriented as seen in the
bottom illustration.
F.
G.
Replace the Value Cap Assembly by aligning the
notches and rotating the cap
1/8
turn clockwise.
Fill
the tank with water and check the operation of
valve by holding the tank by the handle and checking
for leaks.
Disk
\
valve
I
P.12