Filter
Top Products
LEARNING ABOUT YOUR STEAMER
Please refer to the picture for each
point
(1) The control HANDLE on the end of thehose sits
just
before the nozzle. The HANDLE is designed to be
heat free and is safe to grasp. Use the HANDLE to
aim the direction of the steam released from the
nozzle.
(2) The NOZZLE on the end of the handle is located on
the end
of
the steamer hose. Always sit the NOZZLE
end of the hose on the hanger rod when not in use.
Keep the NOZZLE pointed upward and steam will
rise. If you point the NOZZLE downward, water
may condense and drip.
(3) The ROD
is
designed to conveniently hang the hose
handle and
also
can support garments for steaming.
(4) The HOSE extends from the base of the unit. Do not
pull on the HOSE with extreme pressure
or
you may
cause damage and leakage of steam.
(5) The
ON/OFF
switch
is
located on the front of the base.
(6) The WATER CONTAINER is filled through a hole in
the bottom and should be placed in the reservoir on the
base. Avoid spilling excess water into the reservoir
as
this could cause the steamer to expel water from the
nozzle. Do not try to substitute another water container
for the one designed for this
unit.
(7)
The WATER LEVEL can be seen visually in the water
container.
Do
not operate the steamer without water
in
the WATER CONTAINER.
(8)
The steamer BASE houses the reservoir and water
container.
It
also
supports the hanger rod and hose.
(9)
The CASTERS allow the unit to
roll
freely.
(10) The ELECTRICAL CORD plugs into a standard three-
prong plug. Use only three prong UL approved extension
cords with
a
minimum 20-ampere rating.
(11) The DRAIN PLUG is located on the side
for
convenient drainage of the water reservoir.
1
(
12)
The dual hook hanger allows
for
convenient simultaneous hanging
of
the nozzle and clothing.
P.
4