Filter
Top Products
TL-WA750RE
150Mbps Universal WiFi Range Extender User Guide
3
LED Explanation:
Name Status Indication
RE
On
The Range Extender is connected the router successfully.
Flashing
The Range Extender is connecting the router.
Off
The Range Extender is not connected any router yet.
Wireless
Off
The Wireless function is disabled.
Flashing
The Wireless function is enabled.
Power
Off No Power.
On
Power on.
Ethernet
Off
There is no device linked to the corresponding port.
On
There is a device linked to the corresponding port but no activity.
Flashing
There is an active device linked to the corresponding port.
Signal
Strength
Off
No signal at present.
Solid
(1~5)
Signal is transferring. And it also shows the current signal strength
the range extender received from the root AP after successful
connection.
Table 1-1
(RANGE EXTENDER/WPS): If your Wireless router or AP supports WPS or QSS
function, you can press the WPS or QSS button and then press the RANGE EXTENDER
button to establish a secure connection between the Wireless router (or AP) and the Range
Extender TL-WA750RE.
RESET: This button is used to restore the Range Extender’s factory default settings.
There are two ways to reset the Range Extender’s factory defaults:
Method One: With the Range Extender powered on, use a pin to press and hold the RESET
button (about 8 seconds) until the System LED becomes quick-flash from slow-flash. And
then release the button and wait the Range Extender to reboot to its factory default settings.
Method Two: Restore the default settings from “System Tools > Factory Defaults” of the
Range Extender's Web-based management page.
ETHERNET: One 10/100Mbps RJ45 Ethernet port used to add wireless connectivity to an
Ethernet-enabled device such as Internet TV, DVR, Gaming console and so on. Please note
that this port is not allowed to be connected with router or AP.