Filter
Top Products
TL-WA830RE
300Mbps Wireless N Range Extender User Guide
3
LAN
Off
There is no device linked to the corresponding port
On
There is a device linked to the corresponding port but no activity
Flashing
There is an active device linked to the corresponding port
WLAN
Off
The Wireless function is disabled
Flashing
The Wireless function is enabled
WPS
On
The Range Extender has connected the Router successfully
Flashing
The Range Extender is connecting the Router
Off
The Range Extender has not connected any Router yet
Table 1-1
1.3.2 The Rear Panel
Figure 1-2
Viewed from left to right, the following parts are located on the rear panel of TL-WA830RE.
Wireless antenna: Two high gain antennas are used to transmit and receive wireless data.
ON/OFF: This button is to power on or off the Ranger Extender.
POWER: The power port connects to the power adapter provided with the TL-WA830RE 300Mbps
Wireless N Range Extender.
ETHERNET: One 10/100Mbps RJ45 Ethernet port connects to a network device.
RANGE EXTENDER: If your Wireless Router or AP supports WPS or QSS function, you can
press the WPS or QSS button and then press the RANGE EXTENDER button to establish a
secure connection between the Wireless Router (or AP) and the Range Extender TL-WA830RE.
RESET: This button is used to restore the Range Extender’s factory default settings.
There are two ways to reset the Range Extender’s factory defaults:
Method One: With the Range Extender powered on, use a pin to press and hold the Reset
button (about 8 seconds) until the System LED becomes quick-flash from slow-flash. And
then release the button and wait the Range Extender to reboot to its factory default settings.
Method Two: Restore the default settings from “System Tools > Factory Defaults” of the
Range Extender's Web-based management page.