Filter
Top Products
TL-WA830RE
300Mbps Wireless N Range Extender User Guide
24
Mode - If all of the wireless devices connected with this device can connect in the same
transmission mode (eg. 802.11b), you can choose "Only" mode (eg. 11b only). If you have
some devices that use a different transmission mode, choose the appropriate "Mixed" mode.
Channel Width - The bandwidth of the wireless channel.
Max Wireless Rate - You can limit the maximum wireless rate of the device through this field.
Enable Wireless Radio - Select or deselect this check box to allow or deny wireless stations
to access the device.
Note:
To apply any settings you have altered on the page, please click the Save button, and then you
will be reminded to reboot the device.
3) Range Extender mode 1: In this mode, the Range Extender with WDS disabled will relay
data to an associated root AP. AP function is enabled meanwhile. The wireless repeater
relays signal between its stations and the root AP for greater wireless range. Please input the
MAC address of root AP in the field "MAC Address of Root AP".
Figure 4-13 Wireless Settings in Range Extender mode 1
Operation Mode - Three Operation Modes are supported, including: Access Point, Range
Extender mode 2 and Range Extender mode 1.
Survey - Click this button, you can search the AP which runs in the current channel.
Wireless Name of Remote AP - The SSID of the AP your device is going to connect to as a
client. You can also use the search function to select the SSID to join.
MAC Address of Remote AP - The BSSID of the AP your device is going to connect to as a
client. You can also use the search function to select the BSSID to join.