Filter
Top Products
TABLE OF CONTENTS
The serial tag is a permanently afxed label on which is
recorded vital electrical and refrigeration data about your
Traulsen product, as well as the model and serial number.
This tag is located in the left interior compartment on all
standard milk cooler models.
I. THE SERIAL TAG
-1-
READING THE SERIAL TAG
• Serial = The permanent ID# of your Traulsen unit
• Model = The model # of your Traulsen unit
• Volts = Voltage
• Hz = Cycle
• PH = Phase
• Total Current = Maximum amp draw
• Minimum Circuit = Minimum circuit ampacity
• Lights = Light wattage
• Heaters = Heater amperage (Hot Food units only)
• Refrigerant = Refrigerant type used
• Design Pressure = High & low side operating
pressures and refrigerant charge
• Agency Labels = Designates agency listings
I. THE SERIAL TAG Page 1
II. RECEIPT INSPECTION Page 2
III. INSTALLATION
a-Location Page 2
b-Packaging Page 2
c-Installing/Adjusting the Casters Page 2
d-Cord & Plug Page 2
e-Power Supply Page 2
IV. OPERATION
a-Temperature Control Page 2
V. CARE & MAINTENANCE
a-Cleaning The Condenser/Filter Page 3
b-Replacing The Door Gaskets Page 3
c-Cleaning The Cabinet Surface Page 3
VI. WIRING DIAGRAM Page 4
VII. TROUBLE SHOOTING GUIDE Page 5
VIII. SERVICE ASSISTANCE
a-Service Check List Page 5
b-Service Information Page 5
IX. WARRANTIES Page 6
X. SERVICE PARTS LIST Page 7-8
FORT WORTH, TX.
SERIAL MODEL
VOLTS Hz PH
TOTAL CURRENT AMPS
MINIMUM CIRCUIT AMPS
MAXIMUM OVERCURRENT PROTECTION AMPS
LIGHTS WATTS
HEATERS AMPS
REFRIGERANT TYPE OZ
DESIGN PRESSURE HIGH LOW
REFRIGERANT TYPE OZ
DESIGN PRESSURE HIGH LOW
370-60294-00 REV (A)