Filter
Top Products
IV. a - TEMPERATURE CONTROL: (continued)
Colder
Temperature
Adjustment
Shaft
F
R
O
N
T
V. CARE & MAINTENANCE
V. a - CLEANING THE CONDENSER/FILTER:
The most important thing you can do to insure a long, reliable
service life for your Traulsen is to regularly clean the condenser
coil and or lter.
WARNING: DISCONNECT ELECTRICAL POWER SUPPLY
BEFORE CLEANING ANY PARTS OF THE UNIT.
To clean the condenser/lter, rst disconnect electrical power to
the cabinet and remove the system side cover.
Proceed to vacuum or brush any dirt, lint or dust from the nned
condenser coil/lter, the compressor and other cooling system
parts. If signicant dirt is clogging the condenser ns or lter,
use compressed air to blow this clear.To replace the system side
cover reverse the process.
V. b - REPLACING THE DOOR GASKETS:
To remove the gasket to be replaced, grasp it rmly by one corner
and pull it out. Before attempting to install a new gasket, both
the unit and the gasket itself must be at room temperature. Insert
the four corners rst by using a rubber mallet (or hammer with
a block of wood). After the corners are properly inserted, work
your way towards the center from both ends by gently hitting
with a mallet until the gasket is completely seated in place (see
gure below for proper gasket placement).
NOTE: The gasket may appear too large, but if it is installed
as indicated above it will slip into place.
-3-
V. CARE & MAINTENANCE (continued)
V. b - REPLACING THE DOOR GASKETS:
V. c - CLEANING THE CABINET SURFACES:
WARNING: DISCONNECT ELECTRICAL POWER
SUPPLY BEFORE CLEANING ANY PARTS OF THE
UNIT.
Exterior stainless steel should be cleaned with warm wa-
ter, mild soap and a soft cloth. Apply with a dampened
cloth and wipe in the direction of the metal grain.
Avoid the use of strong detergents and gritty, abrasive
cleaners as they may tend to mar and scratch the sur-
face. Do NOT use cleansers containing chlorine, such as
bleach, this may promote corrosion of the stainless steel.
Care should also be taken to avoid splashing the unit with
water, containing chlorinated cleansers, when mopping
the oor around the unit.
For stubborn odor or spills, use baking soda and water
(mixed to a 1 tbsp baking soda to 1 pint water ratio).
A stainless steel polish is recommended for shining of
unit.
The unit is equipped with a drain for cleaning the inside
of the unit.
IV. OPERATION (continued)
Front Door
Gasket
Top Door
Gasket
NOTE: System gasket attached with screw.