Filter
Top Products
III. a - LOUVER ASSEMBLY/SYSTEM ACCESS:
To remove the louver assembly first place your hands
under the louver panel and lift this up off the bracket
and then away from the cabinet face (see figure 3).
To gain full access to the refrigeration system from
the side, remove the cover by removing the bottom
screws (see figures 4 & 5).
When finished, lower the louver assembly into
position and replace the side panel. Secure these in
place using the previously removed screws.
III. b -
EVAPORATOR HOUSING COVER:
Remove the back cover by removing the four screws
which secure this to the cabinet (see figure 6).
Reverse the procedure when done to reinstall.
III. c -
REMOVING THE DRAWERS:
Remove the drawer(s) from the drawer frame by lifting
up on the drawer, and then pulling out.
III. d - REMOVING THE DRAWER FRAME:
Once the drawer(s) have been removed, the drawer
frame module can also be removed by loosening the
front and back clamping knobs (2 of each), located on
the cross-rail and liner locks (see figures 7 & 8). Slide
the front cross-rail locks towards the center of the
drawer frame module and allow the liner locks to drop
down from the top of the liner.Pull the drawer frame
module forward, tip forward and pull out. The entire
frame assembly is now free to slide out of the cabinet.
III. REMOVAL & REPLACEMENT OF BASIC PARTS
-4-
WARNING: DISCONNECT THE ELECTRICAL POWER TO THE MACHINE
AND FOLLOW LOCKOUT/TAGOUT PROCEDURES.
Fig. 3
Fig. 4
Screw
Locations
Fig. 5
Side System
Access
Fig. 7
Fig. 8
Fig. 6