Filter
Top Products
-5-
III. INSTALLATION (continued)
III. l - ELECTRICAL OUTLET INSTALLATION:
Refer to the diagram below to determine the correct location for the electrical outlet for built-in units.
69”
6”
3” 4” 8”
49”
Wall Opening
Electrical Outlet
Installation
For Model UR48DT
NOTE: Wall location of electrical outlet for built-in units and applications that require unit to be counter top
depth, locate outlet in shaded area only.
IV. MISCELLANEOUS PRODUCT FEATURES
IV. a - SOLAR DIGITAL THERMOMETER:
All Spacesaver models are equipped with an external
solar digital thermometer. It has an LED display and
is mounted on the top, left side of the cabinet next to
the louvers.
Thermometers on older Spacesaver models also in-
cluded a battery back-up for use in low-light condi-
tions. Prolonged use of this in low-light conditions
could result in exhausting the battery. To replace the
battery back-up, lift-up the louver assembly as out-
lined in section V. a. Next, remove the screws secur-
ing the thermometer housing cover and replace the
battery.
IV. b - LIGHT SWITCHES:
All Spacesaver models include a concealed light
switch mounted in the top door hinge(s), which auto-
matically activates the interior light when the door is
opened. When the door is closed, the lights are not
operating. In addition, an exterior mounted, illumin-
IV. b - LIGHT SWITCHES (cont’d):
ated red switch is included for manual light control.
Typically this feature is used for units supplied with
glass doors. In the ON position, the lights are illumi-
nated whether the doors are open or not. In the OFF
position, the lights are controlled by the hinge switch
as described in the first paragraph.
IV. c - DEFOGGER CONTROL:
As environmental conditions vary, condensation may
appear on the front of your Spacesaver around the
doors. To control this, Traulsen has included a manual
defogger switch, which is mounted on the top, left side
of the cabinet next to the louvers, below the thermom-
eter.
When in the ON position, anti-condensate heaters
around the door perimeter are activated which help to
evaporate any condensation, and prevent it from re-
curring. This can be turned OFF when not needed in
order to save energy.