Filter
Top Products
10
SET-UP
1. Power Switch is used to turn on or off the Tribest Sedona Combo.
2. °F/°C button will enable you to select the temperature display mode (Fahrenheit or
Celcius).
NOTE: The default setting of Sedona Combo is in Celsius (°C). Once you set the machine
to Celsius or Fahrenheit, the Sedona Combo will remember your setting even after you
turn OFF the switch.
3. Temperature display is used for two separate functions:
• Setting Desired Temperature- During set up this display will be used to set the desired
temperature of the drying compartment.
NOTE: The condition of the inflowing air may adversely affect the actual compartment
temperature. The actual compartment temperature may read a +/- 5°C (9°F)
difference. The difference is registered by the thermal sensor, thus regulating the
heating mechanism activity.
• Temperature Display- Will display your desired temperature setting.
-The 2 icons on the left in the TEMP display indicate which of the two heating
mechanism is active at any given time.
-When the top left icon is lit, the top heating mechanism is active.
-When the bottom left icon is lit, the lower heating mechanism is active.
-When the two icons light up alternately, both heating mechanisms are active.
NOTE: While the temperature displayed by the Temperature Display is set to the desired
setting, the actual temperature in the drying chamber may fluctuate up to ±5°C (41°F).
4. TIMER display will show the total number of hours set for each desired temperature.
This timer automatically counts down, showing the time remaining for dehydrating.
5. SET button has two functions:
• It enables you to set the temperature and the time.
-When initially setting the temperature, press the SET button once and the 3 digit of
the TEMP window will flash.
-When you press the SET button once more, the 2 digit TIMER window will flash.
• Once the temperature and the time is set, the SET button turns on two internal LED
lights while the machine is in operation.
1) Press the SET button once – While the TEMP window flashes, set the desired
temperature by using the 10 or 1 buttons to select your desired temperature.