Filter
Top Products
14
OPERATING INSTRUCTIONS
For your safety and to protect your Tribest Sedona Combo, please follow
the instructions below:
1. Always keep the Tribest Sedona Combo on a level surface.
• Keep the Tribest Sedona Combo at least 10 cm away from walls, other appliances
or furniture.
2. Open the door to insert trays into the Tribest Sedona Combo. Hold the tray in the
horizontal position and push the tray into the proper slots.
• Place the food evenly and neatly on each tray as close as possible (remember dehydrating
removes water and/or shrinks food). For best results, cut the food into even slices.
• It is recommended to use separate trays for each type of food.
• You may dehydrate up to 9 trays simultaneously.
• For 4-5 trays of dehydrated recipes, use the upper compartment for best results.
The white plastic dividers on the side of the Sedona Combo
now help as a simple
visual device to separate upper and lower compartments.
• Double check whether all the trays are properly loaded.
3. Plug into an outlet that has 10 amp capacity.
4. Turn the main switch ON.
5. There are three settings to choose with the Sedona Combo:
• TWO-STAGE SEQUENTIAL TEMPERATURE-TIMER (TST) Use Only
The Two-Stage Sequential Temperature-Timer (TST), a 2-phase mode that allows for both
FAST mode and RAW mode to be applied sequentially. This is the default setting of the
when it is turned on.
1) Turn the Sedona Combo on, both the RED and GREEN lights to the right of the MODE
button will be lit. (Red=FAST mode, Green=RAW mode.)
2) Press the F°/C° button to choose farenheit or celcius.
3) Press the SET button to set FAST mode to your desired temperature using the
UP/DOWN 10 or 1 buttons.
4) Press SET again to set the desired time using the UP/DOWN 10 or 1 buttons for
FAST mode.
5) Press SET again to set the desired temperature using the UP/DOWN 10 or 1 buttons
for RAW mode.
6) Press SET again to set the desired time using the UP/DOWN 10 or 1 buttons for
RAW mode.
7) Press SET to finalize settings.
8) Press the TRAY button to choose the upper, lower, or both drying compartments.
9) Press the START/PAUSE button to begin operation.
NOTE: During FAST mode the upper red light blinks - while the higher temperature operates
first for the desired set time. RAW mode, the lower green light blinks- automatically
lowers the temperature to the second setting for the remaining dehydrating time.