Filter
Top Products
20
Door Reversal
1. Disconnect the appliance from the electricity
supply.
2. Gently lay the fridge/freezer on its back with the
top held away from the floor by 5-8 cm
(2-3 inches) of packaging.
3. Prise out the two white screw covers from the
ventilation grille at the bottom of the appliance.
4. Remove the two securing screws and remove the
grille.
5. Unscrew the bottom hinge.
6. Remove the fridge door by releasing it from the
middle hinge.
7. Unscrew the middle hinge.
8. Slide out the freezer door from the pin, unscrew
the pin and then screw it into the hinge blade
provided on the opposite side.
9. Refit the freezer door on the opposite side and
replace the middle hinge to the left hand side.
10. Replace the fridge door and bottom hinge on the
opposite side.
11. Remove the plug from the ventilation grille in the
direction of the arrow (1) and insert it on the
opposite side (2)
12. Refit the ventilation grille. Secure with the two
screws and push in the screw covers.
13. Return the appliance to its upright position.
Important
After completion of the door reversing operation,
check that the door gasket adheres to the cabinet. If
the ambient temperature is cold (i.e. in Winter), the
gasket may not fit perfectly to the cabinet. In that case,
wait for the natural fitting of the gasket or accelerate
this process by heating the part involved with a normal
hairdryer on a low setting.