Filter
Top Products
19
Something not working
Fault code / malfunction Possible cause Solution
The dishwasher does not fill with
water.
- continuous flashing of the
start/cancel indicator light
- 1 intermittent audible signal
- 1 flash of the "end of
programme" indicator light
The dishwasher will not drain.
- continuous flashing of the
start/cancel indicator light
- 2 intermittent audible signals
- 2 flashes of the "end of
programme" indicator light
The water tap is blocked or furred Clean the water tap.
with limescale.
The water tap is turned off. Turn the water tap on.
The filter (where present) in the . Clean the filter in the.
threaded hose fitting at the water threaded hose fitting.
inlet valve is blocked.
The water inlet hose has not been Check the water inlet hose
correctly laid or it is bent or connection.
squashed.
The sink spigot is blocked. Clean out the sink spigot.
The water drain hose has not been Check the water drain hose
correctly laid or it is bent or connection.
squashed.
The programme does not start.
The dishwasher door has not been Close the door
properly closed.
The main plug is not plugged in. Insert the mains plug
The fuse has blown in the household Replace the fuse.
fuse box.
IMPORTANT!
The dishwasher will not start or stops during operation.
Certain problems are due to the lack of simple maintenance or oversights, which can be solved
with the help of the indications described in the chart, without calling out an engineer.
Open the door and see which fault code is active.
Switch off the dishwasher and carry out the following suggested corrective actions.
Once these checks have been carried out; switch on the dishwasher, press the
Programme/Cancel button and close the door. The programme will continue from the point at
which it was interrupted. If the malfunction or fault code reappears contact the Service Force
Centre.
For other combinations of fault codes not described in the above chart, please contact your
Service Force Centre.
117996 79/0en 4-07-2006 18:04 Pagina 19