Tricity Bendix TBD903 Oven User Manual


 
REPLACING THE OVEN LIGHT BULB
The type of bulb required is a 300°C 25 watt small
Edison Screw. Part number 572 491 5431-00/1.
(Available through Tricity Bendix service centres).
CAUTION: DISCONNECT THE COOKER FROM
THE ELECTRICITY SUPPLY BEFORE REPLACING
THE BULB.
Open door and remove the shelves to enable easy
access to the oven light assembly. Insert a flat blade
screwdriver between the oven side and the glass
which covers the bulb.
Support the glass with your hand and prise out
sufficiently to release the glass cover. Unscrew the
bulb in an anti-clockwise direction until it is possible
to remove the bulb with ease.
Fit the new bulb by turning in a clockwise direction
until it is secure. Ensuring the indent to the flange is
pointing to the rear of the oven, replace the glass by
pushing it firmly into the hole to cover the bulb
assembly.
Replace the shelves. Restore the electricity supply
and adjust the time of day and clock, as necessary.
REMOVING AND REPLACING WIREWORK
SIDE RUNNERS
Remove all shelves and furniture from the oven.
Always ensure the telescopic runners are pushed
back into place in the oven cavity. Hold the bottom of
the wirework runners and draw the runners towards
the centre of the oven. Unhook from the top and
remove.
The telescopic runners should be dried carefully after
washing in hot water to which washing up liquid has
been added. If heavily soiled mild abrasives may be
used.
To replace the runners, hook the wirework side runner
into the cavity, slide back and press into place.
31
Ensure the wirework runners are firmly in
position before replacing the oven shelves.