Filter
Top Products
............ www.truemfg.com ............
True Food Service Equipment, Inc.
8 8
INSTALLATION / OPERATION INSTRUCTIONS
Step 4
A. Before your new unit is connected to a
power supply, check the incoming voltage with a
voltmeter. If anything less than 100% of the rated
voltage for operation is noted, correct immediately.
B. All units are equipped with a 7 ft. (2.1m) service
cord, and must be powered at proper operating
voltage at all times. Refer to cabinet data plate for
this voltage.
True recommends that a sole use circuit be
dedicated for the unit.
WARNING
Compressor warranties are void if compressor burns
out due to low voltage.
WARNING
Power supply cord ground should not be removed!
NOTE
To reference wiring diagram - Remove front louvered
grill, wiring diagram is positioned on the inside cabinet
wall.
ELECTRICAL INSTRUCTIONS
On beer dispensers the drain is located at the
front of the cabinet. To plumb in the drain,
connect
3
⁄4" (2cm) P.V.C. pipe to the
3
⁄4" (2cm)
barbed fitting supplies with the unit.
CO
2
PRESSURE
Mobile tapsters, to retain complete mobility,
the CO
2
tank (up to five pounds in size) can
be placed inside the cooler (strap holders
furnished).
CAUTION
Filled CO
Filled CO
2
2
tanks are potentially dangerous
tanks are potentially dangerous
because of the pressure they contain. If you
because of the pressure they contain. If you
are unfamiliar with their use or the use of the
are unfamiliar with their use or the use of the
CO
CO
2
2
regulator, seek information from your local
regulator, seek information from your local
distributor, or your local beverage man before
distributor, or your local beverage man before
proceeding.
proceeding.
INSTALL DRAFT ARM
Place rubber washer over draft arm mounting
holes in cabinet, put beer line connector
down through hole. Next, secure draft arm
with four screws. (See images 1-6)
BEER DISPENSERS
CONTINUED ON
NEXT PAGE...
Draft arm install contents.
(Draft arm not shown)
Beer line
connector.
Thread beer line connector to draft arm and secure draft
arm to cabinet with rubber gasket under the draft arm.
Thread
beer draft
arm handle
onto the
draft arm.
4
1
2
3
5
6