Filter
Top Products
INSTALL DRAFT ARM continued...
Insert air hose (one inch plastic tube)
in draft arm, being careful not to disturb
insulation. Remove top cover of draft
arm and attach air hose clip to the
insulating sleeve at the top of the draft
arm. Replace top cover. The air hose
clip will assure that the hose remains
in proper place at all times, keeping the
beer faucet cold. (See image 7-9)
............ www.truemfg.com ............
True Food Service Equipment, Inc.
9
9
INSTALLATION / OPERATION INSTRUCTIONS
BEER DISPENSERS CONTINUED...
7
8
9
Step 5
A. The compressor is ready to operate. Plug in the
cooler.
B. Temperature control set at No. 4 position gives
refrigerators an approximate temperature of 35°F
and glass chiller frosters have an approximate
temperature of 0°F. Allow unit to function several
hours, completely cooling cabinet before changing
the control setting.
C. Excessive tampering with the control could
lead to service difficulties. Should it ever become
necessary to replace temperature control, be sure it
is ordered from your True dealer or recommended
service agent.
D. Good air flow in your True unit is critical. Be
careful to load product so that it neither presses
against the back wall, nor comes within four inches
of the evaporator housing. Refrigerated air off the
coil must circulate down the back wall.
LIGHT SWITCH LOCATION:
The switch is located on the front of the
evaporator housing toward the front of the
cabinet. Open the front doors and the switch will
be visible close to the ceiling the cabinet.
NOTE
If the unit is disconnected or shut off, wait five minutes
before starting again.
RECOMMENDATION
Before loading product we recommend you run your
True unit empty for two to three days. This allows you
to be sure electrical wiring and installation are correct
and no shipping damage has occurred. Remember, our
factory warranty does not cover product loss!
REPLACEMENT PARTS
TRUE maintains a record of the cabinet serial number
for your cooler. If at any time during the life of your
cooler, a part is needed, you may obtain this part by
furnishing the model number and serial number to the
company from whom you purchased the cooler. Call
Toll-Free: (800)-424-TRUE (Direct to Parts Department).
(800)-325-6152 (U.S.A. & Canada only) or call: (636)-
240-2400.
STARTUP