Filter
Top Products
............ www.truemfg.com ............
True Food Service Equipment, Inc.
10 10
O
F
F
9
8
7
6
5
4
3
2
1
SHELVING and BIN DIVIDER INSTALLATION /
OPERATION
INSTALLATION / OPERATION INSTRUCTIONS
SHELF INSTALLATION:
A. Hook shelf clips onto shelf standards.
B. Position all four shelf clips equal in distance
from the floor for flat shelves.
C. Shelves are oriented so that cross support bars
are facing down.
D. Place shelves on shelf clips making sure all
corners are seated properly.
HORIZONTAL BOTTLE COOLER BIN DIVIDER
INSTALLATION:
Horizontal bottle coolers are shipped with bin
dividers in place. If it is necessary to adjust spacing
the following procedure is recommended.
Step 1
A. Dividers are spring loaded - push divider
towards rear of the cooler to release from front
grommeted holes.
B. Lineup divider front pegs with desired holes
and punch through interior tape lining of both top
and bottom holes - bottom peg first (front holes are
taped over to improve insulation values).
Remove divider from the front holes and line up
regular and spring loaded rear pegs with holes in
line with those desired in front. Insert as far as
possible and maneuver front pegs in place.
SHELF INSTALLATION
BIN DIVIDER INSTALLATION
NOTE:
Divider positioned
in front of
mechanical box
requires specific
notch cut out.
Draft beer should be treated as a food product. In
most instances draft beer is not pasteurized. It is
very important that you store and handle it properly.
Follow these steps to ensure the highest quality and
consumer satisfaction.
• Draft beer should be immediately stored in a
refrigerated cabinet.
• Draft beer products have a recommended shelf
life. If you have questions regarding the shelf life
of any of your draught products, please consult
with your supplying depot or respective Brewer
representative.
• Kegs should be stored separately from food
products. If your cooler is used to refrigerate
draught and food products, it is very important that
the food not be stored near or on the kegs.
• Keg storage and dispensing areas should be kept
clean to prevent any possibility of contaminating
your draught products.
STORAGE AND HANDLING
Shelf
Clip
Shelf
Shelf
Pillaster
(I-beam)
Shelf
Standards