Filter
Top Products
............ www.truemfg.com ............
True Food Service Equipment, Inc.
9
9
INSTALLATION / OPERATION INSTRUCTIONS
Step 4
A. Before your new unit is connected to a
power supply, check the incoming voltage with a
voltmeter. If anything less than 100% of the rated
voltage for operation is noted, correct immediately.
B. All units are equipped with a 7 ft. (2.1m) service
cord, and must be powered at proper operating
voltage at all times. Refer to cabinet data plate for
this voltage.
True requires that a sole use circuit be dedicated
for the unit. Failure to do so voids warranty.
WARNING
Compressor warranties are void if compressor burns
out due to low voltage.
WARNING
Power supply cord ground should not be removed!
NOTE
To reference wiring diagram - locate the diagram
inside large junction box on top of unit.
ELECTRICAL INSTRUCTIONS
DIGITAL TEMPERATURE DISPLAY
Step 5
A. The compressor is ready to operate. Plug in the
cooler.
B. Temperature control set at No. 4 position gives
refrigerators an approximate temperature of 35°F
and freezers an approximate temperature of -10°F.
Allow unit to function several hours, completely
cooling cabinet before changing the control setting.
C. Excessive tampering with the control could
lead to service difficulties. Should it ever become
necessary to replace temperature control, be sure it
is ordered from your True dealer or recommended
service agent.
D. Good air flow in your True unit is critical. Be
careful to load product so that it neither presses
against the back wall, nor comes within four
inches of the evaporator housing (Interior Top).
Refrigerated air off the coil must circulate down the
back wall.
NOTE
If the unit is disconnected or shut off, wait five
minutes before starting again.
RECOMMENDATION
Before loading product we recommend you
run your True unit empty for two to three days.
This allows you to be sure electrical wiring and
installation are correct and no shipping damage
has occurred. Remember, our factory warranty
does not cover product loss!
REPLACEMENT PARTS
TRUE maintains a record of the cabinet serial
number for your cooler. If at any time during
the life of your cooler, a part is needed, you
may obtain this part by furnishing the model
number and serial number to the company from
whom you purchased the cooler. Call Toll-Free:
(800)-424-TRUE (Direct to Parts Department).
(800)-325-6152 (U.S.A. & Canada only) or call:
(636)-240-2400.
STARTUP
The digital temperature display can view ˚C or ˚F.
To achieve this, there is a small plug that will need
to be removed to achieve ˚C reading. See image 1
for temperature display location. If the plug is kept
in the back of the digital display ˚F will be viewable.
See images for reference. When temperature display is
in ˚C mode place the plug in a safe place so it can be
easily reinstalled for ˚F reading.
˚F
˚C
Image 1 (Rear of Rainshield)
Image 2 Image 3