Filter
Top Products
............ www.truemfg.com ............
True Food Service Equipment, Inc.
11
11
INSTALLATION / OPERATION INSTRUCTIONS
Installation Procedures (Pilasters):
Install slotted thumb screws into threaded holes
along the inside wall of the cabinet.
Slide pilasters into position behind the slotted
screws. Leave all of the thumb screws loose for
adjustments when installing tray slides.
It is critical to measure from the center of the
square hole on the front pilaster to the center hole
of the rear pilaster. This measurement should
be 24 5/8” (See Image 13). Do the same on the
opposite side of cabinet for single door. Make
sure the measurement (24 5/8”) is the same in the
center pilasters in 2 and 3 door units. Tap the tray
slides into the Pilasters with a rubber Mallet.
Angle & Rod Type shelving uses a 18 1/8”
distance between Pilasters. Universal Tray slides
have a 21 1/4” distance between Pilasters. (See
Image14).
After the pilasters are installed the Universal
Tray, Angle Type Tray, and Rod Style Tray Slides
will slide into the pilasters (See Images 7-12).
When disassembling or changing tray slides a
rubber mallet may be used to take out the different
tray slides. Gently tap on the under side of the tray
slide to loosen it from the pilaster.
PILASTER INSTALL/OPERATION CONTINUED...
Type Kit #1 (Angle Type Tray Slide)
Type Kit #2 (Rod Style Tray Slide)
Type Kit #3 (Universal Tray Slide)
7
8
9
10
11
12
24 5/8
13
14
(Critical Measurement Front to Rear Pilasters)
18 1/8”
Angle Type &
Rod Type
21 1/4”
Universal
Tray Slide
Top view (Critical Measurement side to side)