Filter
Top Products
Installation & Service Manual TLM, TLF, TLD
Page 25
GENERAL INFORMATION
Rear Sliding Door Removal
and Installation
The sliding doors come installed from the
factory in the door frames. These doors are
removable for cleaning and to aid in case
maintenance. NOTE: DO NOT FULLY
IMMERSE DOORS WHEN CLEANING. The
inner and outer doors are marked with labels
from the factory. If the doors are not labeled,
the inner door can be identified as having the
limiter stops on it.
1. Remove the outer door (1) by sliding it to
the right end of the door frame (2) (within
an inch of being closed).
2. Firmly grasp both sides of the outer door
(1) and lift into the upper track (3) until it
clears the lower track (4).
3. Tilt out the bottom of the outer door (1)
so it can clear the lower track (4).
4. Lower the outer door (1) out of the upper
track (3) to remove it from the case.
5. Repeat steps 1 thru 4 to remove the
inner door (5).
6. Reverse the above steps to replace the
inner and outer doors (5 and 1).
Grease and oil Organic solvents such as Rub with a cloth. Organic Satisfactory for use on all
carbon tetrachloride, tri- solvents may be flammable finishes.
chlorethylene, acetone, kero- and/or toxic. Observe all
sene, gasoline, benzene, precautions against fire.
alcohol and chlorethane n.u. Do not smoke while vapors
are present. Be sure area
is well ventilated.
* Use of proprietary names is intended only to indicate a type of cleaner, and does not constitute an endorsement, nor is
omission of any proprietary cleanser to imply its inadequacy. It should be emphasized that all products should be used
in strict accordance with instructions on package.
** In all applications a sponge or fibrous brush or pad are recommended. DO NOT use ordinary steel wool, steel brushes,
chlorine bleach or products containing bleach for cleaning or sanitizing stainless steel.
April, 2007