Filter
Top Products
Install the custom insert as follows:
Insert edges may be SHARP! Use care when installing.
1. Open drawer. Pull drawer gas-
ket out of groove (top edge of
drawer only). Start in the mid-
dle and pull outward, moving
toward the edge (Figure 14).
This may take some force, be
careful.
2. Remove the three screws
behind the gasket. Carefully pull
the top handle up and off. You
may discard the top handle as
it will be replaced with the full
handle.
3. Remove the two outside
screws and the lower handle
(Figure 15).
4. Remove existing panel and
cardboard spacer. The panel
and spacer are no longer need-
ed and may be discarded.
!
WARNING
User’s Manual
16
Figure 14
FULL HANDLE
STANDARD
HANDLE
Figure 15
DWR020
FULL HANDLE SHOWN