Filter
Top Products
5. Slide custom drawer panel insert into 1/4" channel in drawer front.
6. Attach the full handle to the lower handle using the 3 screws
removed in step 2.
7. Holding drawer gasket out of the way, replace handle on drawer
making sure it is seated properly on insert and that screw holes line
up.
8. Install two screws removed in step 3.
9. Starting at the corners and working inward, push drawer gasket into
place on the drawer.
INITIAL START-UP AND ADJUSTING
THE TEMPERATURE CONTROL
Once the installation is complete, the unit is ready for initial start-up and
operation.
1. Plug the appliance cord into a 115V polarized, grounded electrical
outlet.
The unit is turned ON with the ON/OFF switch in the front grille (Figure
16). (All units are shipped in the ON position.)
2. Wipe out inside of unit with a clean, water-dampened cloth.
Figure 16
DWR011
OFF
ON
ON/OFF SWITCH
17