Filter
Top Products
2175BEVS/2175BEVOL Beverage Center
www.U-LineService.com 14 01/2007
Leveling Information
Note: It is recommended that the unit is level.
1. Use a level to check the levelness of the Beverage
Center
from front to back and from side to side. Level
should be placed along top edge and side edge as
shown (see Figure 28).
2. If the
Beverage Center
®
is not level, adjust the feet on
the corners of the unit as necessary (see
Figure 29
).
3. Check the levelness after each adjustment and repeat
the previous steps until the unit is level. Go on to
8 Install the Unit
.
Installation Tip
If the room floor is higher than the floor in the cut-out
opening, adjust the rear feet to achieve a total unit rear
height of 1/8
"
less than the opening’s rear height. Shorten
the unit height in the front by adjusting the front feet.
This allows the unit to be gently tipped into the opening.
Readjust the front feet to level the unit after it is correctly
positioned in the opening.
Installation Troubleshooting
Problem
Q:
The door remains open unless it is pushed closed.
Solution
A:
The hinges should be self-closing when the door is open
approximately 8
"
. If this is not the case, make sure the
closers (at the bottom of the hinge pin) are clean, greased
and installed correctly. Also, re-check leveling from front
to back of the unit and readjust if necessary. Make sure
that pivot plate is installed correctly.
7 Level the Unit
1
ULIN_0833_A
Figure 28
Turn Foot to Adjust
Figure 29
8 Install the Unit