U-Line 2175BEVS Refrigerator User Manual


 
2175BEVS/2175BEVOL Beverage Center
www.U-LineService.com 8 01/2007
Final finish-only application:
1. Remove all screws securing wood trim to interior
components, and remove the trim.
2. Lightly scruff sand the wood trim with 280 or finer grit
sandpaper.
3. Remove sanding dust with a clean, dry cloth.
4. The factory-applied seal is compatible with virtually all
finishes. A low odor, water clean up, quick-drying finish
such as Minwax
®
Polycrylic
®
Protective Finish is
recommended (Minwax
®
Polycrylic
®
is an ultra fast-
drying water-based finish). Apply a thin coat of a clear,
protective finish, following the container label
directions.
5. Lightly sand and reapply if desired.
6. Allow the final coat to dry for 24 hours before
reinstalling the trim to the cabinet interior components.
Reversing the Door
(Overlay Units Only)
U-Line units (except
Stainless Steel
models) may be left-
or right-hand
opening. The door
opening is easily
reversed by moving
the hinge hardware
to the opposite side.
The top hinge
hardware will be
used on the bottom
of the other side and
the bottom hinge
hardware will be
used on the top of
the other side (see
Figure 7).
Note: ALL 2175BEVOL units are built and shipped as Right
Handed units. This section is only to be used if a Left
Handed unit is desired.
To reverse the door:
1. Remove screws (3 each, top and bottom) from new
hinge location. Do not discard (see Figure 8).
2. Remove top hinge (3 screws), install hinge screw pin,
and remount on opposite side BOTTOM. Be sure to also
relocate the backing plate located behind the hinge
(see
Figure 9
).
3. Remove the two door closer inserts from additional
package of hardware and install as shown on the new
bottom hinge (see
Figure 10
).
4. Remove existing bottom hinge (3 screws) and remount
on opposite side TOP. Be sure to also relocate the
backing plate located behind the hinge.
ULIN_0015_A
Figure 7
Screw
Figure 8
Pivot Post
Backing plate for hinge
must be in place behind
each hinge
Flush mount screws
in bracket so you can
see head only
Top Pivot Plate
ULIN_0821_A
Figure 9
Figure 10
Door
Closer
Inserts