Filter
Top Products
17
106707
OWNER’S MANUAL
For more information, visit www.desatech.com
REMOVING/REPLACING
GLASS DOOR
CAUTION: Do not operate this
burner system with a broken
glass door panel or without the
glass door panel securely in
place. For replacement part in-
formation see
Replacement
Parts
, page 26.
1. Remove 2 bolts from bottom of stove
(if still installed) and one from the top
of stove to remove front panel (see Fig-
ure 41).
2. Remove the screws from the 2 tabs at
the top of the glass door while holding
door securely keeping it from falling
forward (see Figure 42).
3. Grasp door by both sides and ease it
upward off of the lower bracket (see
Figure 42).
4. To replace glass door, follow the above
instructions in reverse.
You must remove glass door to install logs,
lava rock, and ember material. To remove
glass door, you must first remove the front
panel on stove body.
Figure 39 - Installing Battery in Hand-
Held Remote Control Unit (GHRC Only)
Installing 9-Volt Battery in Hand-
Held Remote Control Unit
1. Remove battery cover on back of re-
mote control unit
2. Attach terminal wires to a 9-volt bat-
tery (not included). Place battery into
the battery housing.
3. Replace battery cover onto remote con-
trol unit.
Terminal
Wires
Battery
Cover
9-Volt
Battery
Remote
Control Unit
Battery Housing
CAST IRON STOVE
AND B-VENT
BURNER SYSTEM
INSTALLATION
Continued
Figure 40 - Installing Battery in Hand-
Held Remote Control Unit (GHRCTA Only)
Terminal
Wires
Battery
Cover
9-Volt
Battery
Remote
Control Unit
Battery Housing
Figure 42 - Removing Glass Door from
Burner System
Figure 41 - Removing Front Panel from
Stove
Screw
Glass
Door
Bolt
Bolt
Stove Front Panel
Continued