Filter
Top Products
Power Up and Default:
1. Turn power on Mixer. (Plug in 115AC)
- 1:00 Appears on the display.
- The slow speed LED lights. (Left LED)
2. Press the bar arrow between the slow and fast LEDs.
- 2:00 Appears on the display.
- The fast speed LED lights. (Right LED)
3. Press the bar arrows between the slow and fast LEDs.
Note: These are the factory default times for slow and fast speed.
The computer will go to factory or stored times on every power up.
Setting The Slow Speed Time:
1. With the computer's Slow speed LED on. (Left LED)
2. Enter the desired time for slow speed.(minutes and seconds)
- Press the time up keys under the display.
- 99:59 is the Maximum time that can be entered.
Setting The Fast Speed Time:
1. Press the bar arrows between the slow and fast LEDs.
2. Enter the desired time for fast speed.(minutes and seconds)
- Press the time up keys under the display.
- 99:59 is the Maximum time that can be entered.
Storing Set Times:
1. With the desired slow and fast speed times entered Press and hold the bar arrow between the LEDs until
“stor” appears on the display. The time stored will be the default time on power up.
Start and Stop:
1. With the desired time for slow and fast speed entered. Press the GREEN Start button.
a. The computer will start the mixer in slow speed counting down from the entered time.
b. The slow speed LED will flash until the slow speed counter counts down.
c. If no time is entered in the slow speed counter the computer will default to a 5 sec. slow speed count down.
d. At the end of slow speed count down the computer will automatically Start the fast speed timer; which will
count down from the entered time and will stop when the counter times out.
e. The fast speed LED will flash until the fast speed counter counts down.
f. Entering 0:00 as the fast speed time will only allow you to run in slow speed.
When the slow speed timer counts down the mixer will stop.
2. The Mixer can also be Stopped by Pressing the RED Stop button.
a. The computer will return to the time entered.
Fixed Mode Operating Procedure
Getting to Fixed mode:
1. With the mixer off (unplugged) Press and hold the four time up keys located under the display.
2. Turn the power on the mixer (plug in 115AC)
3. Release the time up keys when Set appears in the display.
- - - - - appears on the display
b. The time stored from the normal mode will be the fixed time until it is changed.
3
Operation of the Mixer.