Victory Refrigeration VM-2 Refrigerator User Manual


 
SECTION 2
INSTALLATION
IMPORTANT:
It is highly recommended that your
merchandiser refrigerator be installed by
an authorized Victory Certified Installer.
A. Receiving Shipment
Upon arrival, examine the exterior of the
shipment packaging for any signs of rough
handling.
If the cabinet is damaged, it should be noted on
the delivery slip or bill of lading and signed to
that effect. A claim must be filed immediately
against the carrier indicating extent and
estimated cost of damage incurred.
All units are performance tested and thoroughly
inspected, prior to shipment. Upon leaving the
factory, all units are in perfect condition and the
carrier signs to this effect.
B. Uncrating Procedure
WARNING!!!!
DO NOT, Under Any Circumstances, Lay
Your New Equipment Down on Either The
Back, Front or Sides.
The shipping skid must be removed by tipping
the model from side to side. Remove the
leveler bolts while the model is held in one
direction. Repeat this procedure when the
model is held in the opposite direction.
A
TTENTION!!!!
DO NOT THROW AWAY THE FOUR (4)
LEVELER BOLTS!
*Note:Once the uncrating process is complete,
make sure the leveler bolts are safely
and securely placed back on the bottom
of the cabinet for proper support and
leveling purposes.
CAUTION:
Exercise extreme caution when removing
the wooden skid especially when the last
bolt is removed, as the skid, if not properly
blocked, will fall to the floor with extreme
force.
C. Reducing Merchandiser Depth for
Narrow Facility Doorway
In order to pass through a narrow doorway or
restricted area the door, front grille and hinge
brackets may be removed to reduce the overall
depth of the cabinet to a minimum or 30" deep.
1. Removing Hinged Doors
a. Loosen the top hinge bracket screws
while holding the top bracket down.
b. While holding the door against the
cabinet, lift the top bracket until it clears
the top hinge pin.
c. Lift the door until the bottom hinge pin
clears the bottom hinge bracket.
d. Remove top and bottom hinge brackets
and mount on the other side of the
cabinet. Tighten bottom hinge bracket
screws. Leave top hinge bracket screws
loose.
e. Insert bottom hinge pin into hole in
bottom hinge bracket.
f. Lower top hinge bracket onto top hinge
pin. Tighten the top hinge bracket.
D. Locating Your New Merchandiser
The following conditions should be considered
when selecting a location for your
merchandiser refrigerator.
1. Floor Load - The floor on which the cabinet
will rest must be free of vibration and
suitably strong enough to support the
combined weights of the cabinet plus the
maximum product load which might be
6
Section 2- Installation
Section 2- Installation