Filter
Top Products
Disconnect cable from hook.
a
Set counter balance spring connector in appropriate
location.
2
1
b
Increase
tension
Decrease
tension
Reconnect cable to hook.
c
Counter Balance Spring Adjustment - If Necessary
NOTE: For custom panel
installation, the door may
require adjustment to the
preload of the counterbalance
springs. Follow these steps to
adjust the tension.
16 17
Using tie strap attached to dishwasher, band water line,
drain line, and power cord together.
Position unit in front of cutout.
2
3
Installation Procedure
4
Carefully lay dishwasher on its back and attach the kick
plate brackets. Screws for the brackets will already be
in the base. NOTE: Be careful not to pinch hoses or
power cord beneath dishwasher.
1
Slide unit into opening; be sure to feed water, electrical
and discharge lines into adjacent cabinet.
Using a level, adjust to appropriate height. Left and right
adjust side to side and center adjusts front to back.
(Select models only)
Equal distance
5a
DownUp
1b
To adjust the depth of the kick plate, loosen screws on
the bracket and position in the required depth. Tighten
screws and repeat for other side.