Filter
Top Products
17
16
Clocks and Timers
Electronic
Timing Center
The Electronic Timing
Center is used to
program and control
all timing functions on
your Viking appliance.
It has four display and programming modes that are activated by
the four push buttons. Both the Timer and the Cook Time/Stop
Time Modes can be used to time cooking periods. These
features can even be used at the same time when both ovens are
in use. For example, you can time-bake a casserole in the upper
oven using the Cook Time/Stop Time Mode, while broiling in the
lower oven using the Timer. One oven can also be cleaned while
timing foods in the other oven using the timer.
Timer Alarm
• At the end of a program, the alarm will consist of three beeps,
followed by two beeps every 10 seconds until the “CLEAR”
button is pressed.
• Whenever a valid function key is pressed or when a control
function starts automatically, one beep will sound.
• When an invalid function key is pressed, two beeps will sound.
Setting the Clock
The time-of-day must be set before any other program can be
used. When your oven is first connected to the power in your
home, the timer display will show 12:00.
To Program the Time-Of-Day:
1. Press either the “UPPER OVEN” or “LOWER OVEN” button.
2. Press the “CLOCK SET” button. The clock will begin to flash.
The word “CLOCK” will be lit on the display.
3. Type in the correct time on the electronic number keypad.
4. Press the “CLOCK SET” button again. The clock is now set.
Alternate Method:
1. Press either the “UPPER OVEN” or “LOWER OVEN” button.
2. Press the “CLOCK SET” button. The clock will begin to flash.
The word “CLOCK” will be lit on the display.
Programming Modes
Programming Modes
3. Use the up and down arrows to change the current time.
4. Press the “SET” button on the temperature control or the
“CLOCK SET” button on the electronic timing center. The
clock is now set.
Note: The time-of-day cannot be changed while there is a
Bake Hours or Start Time cycle programmed into the timer.
Setting the Timer
The timer is designed for accurate timing and is ideal for baking
delicate items such as biscuits, cookies, and popovers, and for
precise broiling. The timer can be used for timing up to 12 hours.
When setting the timer, the time displayed will decrease in 1
minute increments. When the timer counts down to 1 minute, the
timer alarm will give one short beep and the display will change
to seconds. When the timer reaches 0:00, the alarm will give one
long beep.
To Set the Timer:
1. Press the “TIMER” button. The timer will display “0:00” and
the word “TIMER.”
2. Type in the desired duration time on the electronic number
keypad.
3. The timer will start automatically. (To cancel the entry, press the
“CLEAR” button on the left side of the control panel before
the count down begins and the time is still flashing.)
4. The timer is now set.
Alternate Method:
1. Press the “TIMER” button. The timer will display “0:00” and
the word “TIMER” will be lit on the display.
Press and Release Press and Hold
s
Time increases by one
minute
Time increases by 10
minutes
t
Time decreases by one
minute
Time decreases by
10 minutes
Clocks and Timers