Filter
Top Products
1514
Straight Tube Burner with Glow Bar Ignition
Remove screws securing glow bar igniter to burner box and place glow bar igniter aside.
Remove screws securing metal plate to burner box located underneath griddle burner and
remove metal plate.
Remove screws securing griddle burner to unit and remove griddle burner.
Loosen air shutter screw and adjust opening on burner to 7/16” and tighten air shutter screw.
Use a 1/2” deep socket wrench to remove orifice by turning counterclockwise.
IMPORTANT: If a valve pin is present, remove valve pin and discard.
Install orifice from bag labeled Griddle Orifice.
NOTE: If necessary, repeat steps for 2
nd
burner located on 24” griddles.
Reverse procedures as needed to reassemble.
Griddle Conversion
(for models equipped with griddle)
Screw (Front of Burner)
Screw (Rear of Burner)
Grill Conversion
(for models equipped with grill)
Lift flavor grids from unit.
Lift flavor grid support from unit.
Remove screws securing rear bracket to burner box.
Remove screws securing flame shield to burner box.
Lift out left and right side burner box liners.
Remove screws securing burner to burner box.
Loosen air shutter screw and adjust opening on burner to 7/16” and tighten air shutter screw.
Remove orifice by turning counterclockwise and replace with orifice from bag labeled Grill
Orifice.
IMPORTANT: The orifice tip must be located 3/16” inside the burner for proper gas mixture
and combustion. The depth of the orifice can be adjusted by turning the orifice
counterclockwise (more depth) or clockwise (less depth).
Reverse procedures as needed to reassemble.
Screw (Front of Burner)
Screw (Rear of Burner)
Grill
Burner