Viking LPKPDR Convection Oven User Manual


 
1716
Wok Conversion
(for models equipped with wok)
Remove center trivet and/or grates, center ring and grate support.
Lift and remove burner from unit.
Loosen air shutter screw and adjust opening on burner to 5/8” and tighten air shutter screw.
Remove orifice by turning counterclockwise and replace with orifice from bag labeled Wok
Orifice.
IMPORTANT: The orifice tip must be located 3/16” inside the burner for proper gas mixture
and combustion. The depth of the orifice can be adjusted by turning the orifice
counterclockwise (more depth) or clockwise (less depth).
Reverse procedures as needed to reassemble.
Overhead
View
Air Shutter
Orifice
Bake Conversion
“L” Shaped
Remove oven racks and rack supports.
Remove oven bottom by sliding toward rear of range, then lift upward.
Remove screws securing toe grille to unit.
Remove screws securing burner support bracket to frame of unit and remove burner support
bracket.
Slide bake burner to the left off of orifice and pull bake burner straight out through available
clearance.
Loosen air shutter screw and adjust opening on burner to 7/16” and tighten air shutter screw.
Remove orifice by turning counterclockwise and replace with orifice from bag labeled Oven
Burner Orifice (L-Shape).
IMPORTANT: The orifice tip must be located 3/16” inside the burner for proper gas mixture
and combustion. The depth of the orifice can be adjusted by turning the orifice
counterclockwise (more depth) or clockwise (less depth).
To reinstall burner, position rear of burner into slot on rear wall of burner box then place front
of burner onto orifice.
Reverse procedure as needed to reassemble.