Filter
Top Products
21
1
2
3
4
5
6
Final Installation (36”W. Single)
Lift oven into position.
Push oven straight into cabinet.
Remove all knobs, push buttons, and bezels on the
right control panel.
Remove lower access panel, side trim, and
control panel.
Insert four wood screws, (included with the oven),
through the cabinet side flange into the cabinet.
Replace lower access panel, side trim, and
control panel.
20
1
Note: Refer to “Electrical & Gas
Requirements” section for proper
installation information.
Connect gas and electrical. Before placing appliance in
operation, always check for gas leaks. This must be
performed by your dealer, a qualified licensed plumber,
or gas service company.
Connecting Gas & Electrical (36”W.)
DANGER
Gas leak hazard.
To avoid risk of personal injury
or death; leak testing of the
appliance must be conducted
according to the manufacturer’s
instructions. Before placing appliance in
operation, always check for gas leaks
with soapy water solution.
• DO NOT USE AN OPEN FLAME TO
CHECK FOR GAS LEAKS.
WARNING
Electrical shock hazard.
To avoid the risk of electrical
shock, personal injury or death;
verify your appliance has been
properly grounded in accordance with
local codes or in absence of codes, with
the National Electrical Code (NEC).
ANSI/NFPA 70-latest edition.